Alarm Lock Eagle 6000 Bedienungsanleitung PDF herunterladen (Seite 8)

ES2400 – ES2403 – ES4800 - ES6000

User's Manual

___________________________________________________________________________________________________________________________________________________

4. HOW TO USE THE CHARGER

PROGRAMMATION OF THE FINISHING CHARGE TIME

The programmabie finishing charge times are 2 to 12 hours in the MRG Charge Controller.

The default value (factory programmed) is 3 hours.

Behind the small hole located near the LED “80% CHARGED”, there is a button that is used to

program the finishing charge time. This button can be reached using a small object, like a

needle, a small screwdriver or a toothpick.

• Disconnect the charger from the AC input.

• Connect a battery. The four status LEDs will blink alternately.

• Push the button for the programmation of the finishing

charge time to enter the programming mode. Only one

LED will blink. This LED corresponds to the finishing

charge time that was previously programmed, with

reference to the picture on the right.

• Push the button again to move the blinking LED to the

desired position.

• Wait for 5 seconds. The charger will return to normal

mode, and the four status LEDs will blink alternately.

• Disconnect the battery.

__________________________________________________________________________________________________________________________________________________

Page 8/14

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 17 18

Keine Kommentare

Alarm Lock Eagle 6000 Bedienungsanleitung Seite 8